Filter
Top Products
A – Command Line Interface
Show Command
59022-03 D A-41
FBusy Number of times the switch sent a P_BSY because Class 2
frame could not be delivered within ED_TOV time. Number
of class 2 and class 3 fabric busy (F_BSY) frames generated
by this port in response to incoming frames. This usually
indicates a busy condition on the fabric or N_port that is
preventing delivery of this frame.
Flowerrors Received a frame when there were no available credits.
FReject Number of frames from devices that were rejected.
InvalidCRC Invalid CRC detected.
InvalidDestAddr Invalid destination address detected.
LIP ALPD ALPS Number of F7, AL_PS LIPs, or AL_PD (vendor specific)
resets, performed.
LIPF7ALPS This LIP is used to reinitialize the loop. An L_port, identified
by AL_PS, may have noticed a performance degradation
and is trying to restore the loop.
LIPF8ALPS This LIP denotes a loop failure detected by the L_port
identified by AL_PS.
LIPF7F7 A loop initialization primitive frame used to acquire a valid
AL_PA.
LIPF8F7 A loop initialization primitive frame used to indicate that a
loop failure has been detected at the receiver.
Link Failures Number of optical link failures detected by this port. A link
failure is a loss of synchronization for a period of time
greater than the value of R_T_TOV or by loss of signal while
not in the offline state. A loss of signal causes the switch to
attempt to re-establish the link. If the link is not
re-established by the time specified by R_T_TOV, a link
failure is counted. A link reset is performed after a link
failure.
Login Time when user logged in.
Logout Time when user logged out.
LoopTimeouts A two (2) second timeout as specified by FC-AL-2.
LossOfSync Number of synchronization losses (>100 ms) detected by
this port. A loss of synchronization is detected by receipt of
an invalid transmission word.
Table A-11. Show Port Parameters (Continued)
Entry Description