Filter
Top Products
2 – Using SANbox Manager
Starting SANbox Manager
2-6 59022-03 D
If the default fabric view file exists, the system prompts you to enter the file
password as shown in Figure 2-2. Enter the password and choose the Load View
File button to open the SANbox Manager application and load a previously saved
set of fabrics. Otherwise, choose the Continue Without Loading button to open
an empty fabric view. Choose Add button to open the Add a New Fabric window
shown in Figure 2-3.
Figure 2-2. Load Default Fabric View File Window
To start using the SANbox Manager application, do the following to add a fabric:
1. Open the Fabric menu and select Add Fabric to open the Add a New Fabric
window as shown in Figure 2-3.
Figure 2-3. Add a New Fabric Window
2. Enter a fabric name and the IP address of the switch through which to
manage the fabric.
3. Enter an account name and a password. The factory account name is
"admin" and the factory password is "password". If security is turned off
(default), you are not required to enter an account name or password. This
password is for the switch and is stored in the switch firmware. Refer to the
User Command on page A-59 for more information.
4. Choose the Add Fabric button.