Filter
Top Products
7–Removal and Replacement
iSR6200 Chassis Blades
ISR651101-00 J 7-7
4. Disconnect all cables from the iSR6200 blade. This includes all Fibre
Channel, Ethernet, and serial cables. You can leave the power cables
connected. (See Figure 7-5.)
Figure 7-5. iSR6200 Router Blade with Cables Disconnected
5. Remove the old blade from the chassis. Figure 7-6 shows how to release
the latch and pull down on the lever on the right side (1), and then pull
straight back on the handle (2).
Figure 7-6. Removing the Chassis Blade
NOTE
After you have installed the new blade, you must access it. Use a
computer with a TCP/IP interface capable of using Telnet to connect to
the new blades default IP address of 10.0.0.1. Make sure you have
such a computer available before you remove your old blade, and that
the computer has the FRU file on it you saved in step 3.
(1)
(2)