Q-Logic 6200 SERIES Network Router User Manual


 
C–Log Messages
ISR651101-00 J C-29
151913 qapimaptargetdevice_1_svc: Target WWPN:
%.2x%.2x%.2x%.2x%.2x%.2x%.2x%.2x unmapped
from iSCSI portal %d.
User Info The target at WWPN: xx.xx.xx.xx.xx.xx.xx.xx has
been unmapped from iSCSI portal %d
152082 qapiaddmodifyinitiator_1_svc : Initiator
Configuration Changed
User Info An initiator’s configuration has changed.
152083 qapiremoveinitiator_1_svc : Initiator
Removed
User Info An initiator has been removed.
152096 qapisetmigrfctargets_1_svc: Configuration
Changed for migration target
User Info A set array was done on one of the arrays.
152099 LogMigration: Error in Writting log file User Info Encountered an error while updating the migration
log entry. Some migration log entries might be miss-
ing.
152100 qapiaddgroup_1_svc: Added Group with id %d User Info Group with ID specified in the log was added.
152101 qapiremovegroup_1_svc: Removed Group with
id %d
User Info Group with ID specified in the log was removed.
152102 qapiupdategroup_1_svc: Updated Group with
id %d
User Info Group with ID specified in the log was updated.
152103 qapisetserialjobs_1_svc: Serial Time %lu User Info Serial schedule jobs scheduled to start at time speci-
fied in the log.
152104 qapireadjustpriority_1_svc: Readjust
Priority Failed on line %d with error %d
User Info Readjust priority command completed with an error.
Error code 2 indicates no scheduled jobs were found.
Error code 16 indicates a job with priority 1 config-
ured.
Table C-1. iSR6200 Router Log Messages (Continued)
ID Log Message
Module
Type
Msg.
Type
Description