Q-Logic 6200 SERIES Network Router User Manual


 
1–Introduction
iSR6200 Router Blades
ISR651101-00 J 1-11
Maintenance Button
The maintenance button shown in Figure 1-10 is the only router blade control.
Press this button to reset the router blade or to recover it if it becomes disabled.
Figure 1-10. Router Blade Controls
The maintenance button is a multifunction momentary switch on the front panel. It
has the following functions:
“Reset a Router Blade” on page 1-11
“Reset and Select Boot Image” on page 1-12
“Reset IP Address” on page 1-12
“Enable DHCP” on page 1-12
“Restore Factory Defaults” on page 1-12
Reset a Router Blade
To reset the router blade, use a pointed, nonmetallic tool to momentarily press and
release (less than two seconds) the maintenance button. The router responds as
follows:
1. All the router blade LEDs light up.
2. After about two seconds, the POST begins, turning off the heartbeat and
system fault LEDs.
3. When the POST is complete, the power LED is on and the heartbeat LED
flashes once per second.
MGMT IOIOI
FC1 FC2 GE1 GE1
GE4 GE3 iSR6240
Intelligent Storage Router
iSR6200 System
10GbE1 iSR6250
Intelligent Storage Router
10GbE2
Maintenance Button