Filter
Top Products
3–Installation
Installing New Firmware
ISR651101-00 J 3-19
2. Enter your user name and password. For example:
User (172.17.137.190:(none)): ftp
331 Guest login ok, type your name as password.
Password: ftp
230 Guest login ok, access restrictions apply.
3. At the ftp prompt, type bin to set binary mode. For example:
ftp> bin
200 Type set to I.
4. Use the put command to transfer the firmware image file from the
workstation to the router. For example:
ftp> put isr-6200-3_0_0_5.bin
200 PORT command successful.
150 Opening BINARY mode data connection for
'isr-6200-3_0_0_5.bin'.
226 Transfer complete.
ftp: 4822816 bytes sent in 0.41Seconds 11878.86Kbytes/sec.
5. Enter quit.
The firmware image has been transferred to the router.
6. At a Telnet prompt, log on to the router as an administrator.
7. Select one of the blades.
8. Enter the following command from the router, where x indicates the
firmware image name:
image unpack isr-62xx-x_x_x_x.bin
The following message appears:
Unpack Completed. Please reboot the system for FW to take
effect.
9. Enter reboot.
The following message appears:
Are you sure you want to reboot the System (y/n):
10. To reboot the system, type y.
11. If a second blade is installed, repeat this procedure.