Filter
Top Products
4513/4514 Group User’s Manual
APPENDIX
3-31
3.5 Mask ROM order confirmation form
✽ 1. Confirmation
Specify the type of EPROMs submitted.
Three sets of EPROMs are required for each pattern (check in the approximate box).
If at least two of the three sets of EPROMs submitted contain the identical data, we will produce
masks based on this data. We shall assume the responsibility for errors only if the mask ROM data
on the products we produce differ from this data. Thus, the customer must be especially careful in
verifying the data contained in the EPROMs submitted.
Microcomputer name: M34513M4-XXXSP M34513M4-XXXFP
Checksum code for entire EPROM area (hexadecimal notation)
EPROM Type:
Company
name
Date
issued
Date:
✽ Customer
27C256
27C512
Low-order
5-bit data
High-order
5-bit data
000016
0FFF16
400016
4FFF16
7FFF16
4.00K
4.00K
Low-order
5-bit data
High-order
5-bit data
000016
0FFF16
400016
4FFF16
FFFF16
4.00K
4.00K
Set “FF16” in the shaded area.
Set “1112” in the area of low-order and high-order 5-bit data.
✽ 2. Mark Specification
Mark specification must be submitted using the correct form for the type of package being ordered.
Fill out the approximate Mark Specification Form (32P4B for M34513M4-XXXSP, 32P6B-A for
M34513M4-XXXFP) and attach to the Mask ROM Order Confirmation Form.
✽ 3. Comments
TEL ( )
Mask ROM number
Date:
Section head
signature
Supervisor
signature
Responsible
officer
Supervisor
Issuance
s
ignature
Receipt
GZZ-SH52-44B <81A0>
4500 SERIES MASK ROM ORDER CONFIRMATION FORM
SINGLE-CHIP MICROCOMPUTER M34513M4-XXXSP/FP
MITSUBISHI ELECTRIC
Please fill in all items marked ✽ .