Filter
Top Products
6-4 Riverstone Networks RS Switch Router User Guide Release 8.0
SmartTRUNK Example Configuration SmartTRUNK Configuration Guide
The following is the configuration for the Cisco 7500 router:
The following is the configuration for the Cisco Catalyst 5000 switch:
The following is the SmartTRUNK configuration for the RS labeled ‘R1’ in the diagram:
The following is the SmartTRUNK configuration for the RS labeled ‘R3’ in the diagram:
The following is the SmartTRUNK configuration for the RS labeled ‘R2’ in the diagram:
Note
Notice in the example above that because R1 and R2 are operating only as
switches (layer-2 traffic only), their SmartTRUNKs were not assigned to
interfaces.
interface port-channel 1
ip address 10.1.1.1 255.255.255.0
ip route-cache distributed
interface fasteth 0/0
no ip address
channel-group 1
set port channel 3/1-2 on
smarttrunk create st.1 protocol no-protocol
smarttrunk create st.2 protocol huntgroup
smarttrunk create st.3 protocol huntgroup
smarttrunk add ports et.1(1-2) to st.1
smarttrunk add ports et.2(1-2) to st.2
smarttrunk add ports et.3(1-2) to st.3
interface create ip to-cisco address-netmask 10.1.1.2/24 port st.1
interface create ip to-s1 address-netmask 11.1.1.2/24 port st.2
interface create ip to-s2 address-netmask 12.1.1.2/24 port st.3
smarttrunk create st.2 protocol huntgroup
smarttrunk create st.4 protocol no-protocol
smarttrunk add ports et.1(1-2) to st.2
smarttrunk add ports et.2(1-2) to st.4
smarttrunk create st.3 protocol huntgroup
smarttrunk create st.5 protocol no-protocol
smarttrunk add ports et.1(1-2) to st.3
smarttrunk add ports et.2(1-2) to st.5