Filter
Top Products
Riverstone Networks RS Switch Router User Guide Release 8.0 29-3
LFAP Configuration Guide Monitoring the LFAP Agent on the RS
The
accounting 15-minutes
keyword tells the accounting server what size flow records to create. It does not
affect the RS. For example, the
accounting 15-minutes
keyword causes the accounting server to break flows
on exact 15 minute boundaries (e.g. 10:00, 10:15, 10:30, etc.). This allows the billing application to calculate a bit
rate. For example, the application could ask for all records in the 10:00 to 10:15 slot, sum the bytes and divide by
900 to get bits/second during that period.
Note
This feature is not currently supported on the simple server located at
www.nmsops.org.
2.
Identify the primary (and secondary) accounting server system to which the RS will send LFAP
messages (up to three accounting servers can be configured)
:
3.
Start the LFAP protocol on the RS:
29.5 MONITORING THE LFAP AGENT ON THE RS
The
lfap show
commands display information about the configuration of the LFAP agent on the RS and its current
status. Use the following commands in Enable mode to view LFAP agent information
:
Note
LFAP information is also available through the RS’s SNMP agent.
rs(config)# lfap set server 134.141.170.82
rs(config)# lfap start
Table 29-1 LFAP monitoring commands
Command Displays
lfap show configuration
Configuration of the LFAP agent on the RS.
lfap show servers
Configured accounting server(s) to which the LFAP agent
could connect.
lfap show statistics
Statistics collected by the LFAP agent.
lfap show status
Server to which the LFAP agent is currently connected and
the current status of the LFAP agent.
lfap show all
All of the above information.