Filter
Top Products
Riverstone Networks RS Switch Router User Guide Release 8.0 28-13
RMON Configuration Allocating Memory to RMON
28.6 ALLOCATING MEMORY TO RMON
RMON allocates memory depending on the number of ports enabled for RMON, the RMON groups that have been
configured, and whether or not default tables have been turned on or off. Enabling RMON with all groups (Lite,
Standard, and Professional) with default tables uses approximately 300 Kbytes per port. If necessary, you can
dynamically allocate additional memory to RMON.
To display the amount of memory that is currently allocated to RMON, use the following CLI command in Enable
mode:
Any memory allocation failures are reported. The following is an example of the information shown with the
rmon
show status
command:
To set the amount of memory allocated to RMON, use the following CLI command in User or Enable mode:
Displays the memory allocated to RMON.
rmon show status
rs#
rmon show status
RMON Status
-----------
* RMON is ENABLED
* RMON initialization successful.
+--------------------------+
| RMON Group Status |
+-------+--------+---------+
| Group | Status | Default |
+-------+--------+---------+
| Lite | On | Yes |
+-------+--------+---------+
| Std | On | Yes |
+-------+--------+---------+
| Pro | On | Yes |
+-------+--------+---------+
RMON is enabled on: et.5.1, et.5.2, et.5.3, et.5.4, et.5.5, et.5.6, et.5.7, et.5.8
RMON Memory Utilization
-----------------------
Total Bytes Available: 48530436
Total Bytes Allocated to RMON: 4000000
Total Bytes Used: 2637872
Total Bytes Free: 1362128
Specifies the total amount of Mbytes of memory allocated to RMON.
rmon set memory
<number>