Filter
Top Products
28-10 Riverstone Networks RS Switch Router User Guide Release 8.0
Displaying RMON Information RMON Configuration
1
To display Ethernet statistics and related statistics for WAN ports, RMON has to be activated on that port. To activate
RMON on a port, use the
frame-relay define service
or
ppp define service
command, and the
frame-relay apply service
or
ppp apply service
command. For additional information, refer to
Section 30.4.2, "Setting up a Frame Relay Service Profile" (for frame relay) and Section 30.8.2, "Setting up a PPP
Service Profile" (for PPP).
28.4.1 RMON CLI Filters
Because a large number of statistics can be collected for certain RMON groups, you can define and use CLI filters to
limit the amount of information displayed with the
rmon show
commands. An RMON CLI filter can only be applied
to a current Telnet or Console session.
The following shows Host table output without a CLI filter:
To show all user history logs.
rmon show user-history
To show probe configuration.
rmon show probe-config [basic] [net-config]
[trap-dest]
rs#
rmon show hosts et.5.4
RMON I Host Table
Index: 503, Port: et.5.4, Owner: monitor
Address InPkts InOctets OutPkts OutOctets Bcst Mcst
------- ------ -------- ------- --------- ---- ----
00001D:921086 0 0 102 7140 0 0
00001D:9D8138 1128 75196 885 114387 0 0
00001D:A9815F 0 0 102 7140 0 0
00105A:08B98D 0 0 971 199960 0 0
004005:40A0CD 0 0 51 3264 0 0
006083:D65800 0 0 2190 678372 0 0
0080C8:E0F8F3 0 0 396 89818 0 0
00E063:FDD700 0 0 104 19382 0 0
01000C:CCCCCC 2188 678210 0 0 0 0
01005E:000009 204 14280 0 0 0 0
0180C2:000000 1519 97216 0 0 0 0
030000:000001 168 30927 0 0 0 0
080020:835CAA 885 114387 1128 75196 0 0
980717:280200 0 0 1519 97216 0 0
AB0000:020000 2 162 0 0 0 0
FFFFFF:FFFFFF 1354 281497 0 0 0 0