Filter
Top Products
13-2 Riverstone Networks RS Switch Router User Guide Release 8.0
Configuring RIP Parameters RIP Configuration Guide
To add RIP interfaces, enter the following commands in Configure mode.
13.2 CONFIGURING RIP PARAMETERS
No further configuration is required, and the system default parameters will be used by RIP to exchange routing
information. These default parameters may be modified to suit your needs by using the
rip set interface
command.
To change RIP parameters, enter the following commands in Configure mode.
Add interfaces to the RIP process.
rip add interface
<interfacename-or-IPaddr>
Add gateways from which the RS
will accept RIP updates.
rip add trusted-gateway
<interfacename-or-IPaddr>
Define the list of routers to which
RIP sends packets directly, not
through multicast or broadcast.
rip add source-gateway
<interfacename-or-IPaddr>
RIP Parameter Default Value
Version number RIP v1
Check-zero for RIP reserved parameters Enabled
Whether RIP packets should be broadcast Choose
Preference for RIP routes 100
Metric for incoming routes 1
Metric for outgoing routes 0
Authentication None
Update interval 30 seconds
Set RIP Version on an interface to
RIP V1.
rip set interface
<interfacename-or-IPaddr>
|all
version 1
Set RIP Version on an interface to
RIP V2.
rip set interface
<interfacename-or-IPaddr>
|all
version 2
Specify that RIP V2 packets should
be multicast on this interface.
rip set interface
<interfacename-or-IPaddr>
|all
type multicast