Filter
Top Products
8-20 Riverstone Networks RS Switch Router User Guide Release 8.0
Routing ATM Traffic ATM Configuration Guide
Following is the configuration for RS1:
Configure an interface on each ethernet port.
rs1(config)# interface create ip subnetA address-netmask 10.1.1.130/24
port et.2.4 up
rs1(config)# interface create ip subnetB address-netmask 20.1.1.130/24
port et.2.3 up
Create the virtual channels.
rs1(config)# atm create vcl port at.4.2.0.100
rs1(config)# atm create vcl port at.4.2.0.101
Configure an interface on each ATM port.
rs1(config)# interface create ip ubrservice address-netmask
40.1.1.127/24 peer-address 40.1.1.128/24 port at.4.2.0.101 up
rs1(config)# interface create ip cbrservice address-netmask
30.1.1.127/24 peer-address 30.1.1.128/24 port at.4.2.0.100 up
Define the ATM service profiles.
rs1(config)# atm define service ubrservice srv-cat ubr pcr-kbits 20000
rs1(config)# atm define service cbrservice srv-cat cbr pcr-kbits 100000
Apply the ATM service profiles.
rs1(config)# atm apply service ubrservice port at.4.2.0.101
rs1(config)# atm apply service cbrservice port at.4.2.0.100
Create IP ACLs.
RS1(config)# acl subnetAtoCacl permit 10.1.1.0/24 any any any
rs1(config)# acl subnetBtoCacl permit 20.1.1.0/24 any any any
Specify a gateway for each IP policy.
rs1(config)# ip-policy subnetAtoCpolicy permit acl subnetAtoCacl
next-hop-list 40.1.1.128/24 action policy-first
rs1(config)# ip-policy subnetBtoCpolicy permit acl subnetBtoCacl
next-hop-list 30.1.1.128/24 action policy-first
Apply the IP policies to the ethernet ports.
rs1(config)# ip-policy subnetAtoCpolicy apply interface subnetA
rs1(config)# ip-policy subnetBtoCpolicy apply interface subnetB