Filter
Top Products
Riverstone Networks RS Switch Router User Guide Release 8.0 17-85
MPLS Configuration Configuring L2 Tunnels
Two LSPs are configured on R1. The LSP from R1 to R5 is configured with a strict explicit path of 3 hops (R1, R6,
and R5) and is restricted to traffic destined for the 152.1.0.0/16 subnet. The LSP from R1 to R3 is configured with a
loose explicit path of 2 hops. The following is the configuration for R1:
! Configure VLANs and interfaces
vlan make trunk-port gi.2.1
customer ports must be trunk ports for 802.1q packets
vlan make trunk-port gi.6.2
customer ports must be trunk ports for 802.1q packets
vlan make trunk-port gi.5.1
customer ports must be trunk ports for 802.1q packets
vlan create ldp_in port-based id 110
vlan create ldp_in2 port-based id 120
vlan add ports gi.4.2 to ldp_in2
vlan add ports gi.4.1 to ldp_in
interface create ip to_rs2_1 address-netmask 200.1.1.1/16 vlan ldp_in
LDP-signaling VLAN interface
interface create ip to_rs2_second address-netmask 201.1.1.1/16 vlan ldp_in2
LDP-signaling VLAN
interface
interface add ip lo0 address-netmask 111.1.1.1/32
! Configure OSPF
ip-router global set router-id 111.1.1.1
ospf create area backbone
ospf add stub-host 111.1.1.1 to-area backbone cost 5
ospf add interface to_rs2_1 to-area backbone
ospf add interface to_rs2_second to-area backbone
ospf add interface ip_to_rs3000 to-area backbone
ospf start
! Configure MPLS
mpls add interface to_rs2_1
mpls add interface to_rs2_second
! Configure explicit path p1 to R3
mpls create path p1 num-hops 2
mpls set path p1 ip-addr 200.1.1.1 type loose hop 1
mpls set path p1 ip-addr 210.1.1.2 type loose hop 2
! Configure explicit path to R5
mpls create path to_rs5_primary num-hops 3
mpls set path to_rs5_primary ip-addr 201.1.1.1 type strict hop 1
mpls set path to_rs5_primary ip-addr 201.1.1.2 type strict hop 2
mpls set path to_rs5_primary ip-addr 220.1.1.2 type strict hop 3
! Configure LSP to R3 with explicit path p1
mpls create label-switched-path to_rs3_rsvp to 111.1.1.3 no-cspf preference 10
mpls set label-switched-path to_rs3_rsvp primary p1 no-cspf retry-interval 5 mtu 1000
! Configure LSP to R5
mpls create label-switched-path to_rs5_rsvp to 111.1.1.5 no-cspf
mpls create policy dip_to_rs5 dst-ipaddr-mask 152.1.0.0/16
mpls set label-switched-path to_rs5_rsvp policy dip_to_rs5