Filter
Top Products
10-2 Riverstone Networks RS Switch Router User Guide Release 8.0
Configuring DHCP DHCP Configuration Guide
10.1.1 Configuring an IP Address Pool
To define a pool of IP addresses that the DHCP server can assign to a client, enter the following command in Configure
mode:
10.1.2 Configuring Client Parameters
You can configure the client parameters shown in the table below.
To define the parameters that the DHCP server gives the clients, enter the following command in Configure mode:
Define pool of IP addresses to be used by
clients.
dhcp
VFRSH!
define pool
LSUDQJH!
Table 10-1 Client parameters
Parameter Value
address-mask
Address/netmask of the scope’s subnet (This parameter is required
and must be defined before any other client parameters are
specified.)
broadcast
Broadcast address
bootfile
Client boot file name
dns-domain
DNS domain name
dns-server
IP address of DNS server
gateway
IP address of default gateway
lease-time
Amount of time the assigned IP address is valid for the system
netbios-name-server
IP address of NetBIOS Name Server (WINS server)
netbios-node-type
NetBIOS node type of the client
netbios-scope
NetBIOS scope of the client
Define client parameters.
dhcp
VFRSH!
define parameters
SDUDPHWHU!YDOXH!