Filter
Top Products
Riverstone Networks RS Switch Router User Guide Release 8.0 30-61
WAN Configuration Scenarios for Deploying Channelized T1, E1 and T3
rsite RS 3000 Configuration
The following configuration applies to the RS 3000 router at the remote site, rsite.
!-----------------------------------------------------------------------------
!Configuration for the RS 3000 T1 interfaces
!-----------------------------------------------------------------------------
!T1 interfaces to the MSP:
!-----------------------------------------------------------------------------
port set t1.2.1 framing esf lbo -7.5db
port set t1.2.1:1 timeslots 1-24 wan-encapsulation ppp
port set t1.2.2 framing esf lbo -7.5db
port set t1.2.2:1 timeslots 1-24 wan-encapsulation ppp
port set t1.2.3 framing esf lbo -7.5db
port set t1.2.3:1 timeslots 1-24 wan-encapsulation ppp
port set t1.2.4 framing esf lbo -7.5db
port set t1.2.4:1 timeslots 1-24 wan-encapsulation ppp
ppp create-mlp mp.1 slot 2
ppp add-to-mlp mp.1 port t1.2.(1-4):1
interface create ip to_msp_mppp address-netmask 120.210.23.50/28 port mp.1 up
!-----------------------------------------------------------------------------
!Fractional T1 interface to the MSP:
!-----------------------------------------------------------------------------
port set t1.3.1 framing esf lbo -7.5db
port set t1.3.1:1 timeslots 1-12 wan-encapsulation ppp
port set t1.3.1:2 timeslots 13-18 wan-encapsulation ppp
port set t1.3.1:3 timeslots 19 wan-encapsulation ppp
port set t1.3.1:4 timeslots 20 wan-encapsulation ppp
port set t1.3.1:5 timeslots 21 wan-encapsulation ppp
port set t1.3.1:6 timeslots 22 wan-encapsulation ppp
port set t1.3.1:7 timeslots 23 wan-encapsulation ppp
port set t1.3.1:8 timeslots 24 wan-encapsulation ppp
interface create ip to_msp_ft1 address-netmask 120.210.23.66/28 port t1.3.1 up
!-----------------------------------------------------------------------------
!Full (unstructured) T1 interface to the hqsite:
!-----------------------------------------------------------------------------
port set t1.3.2 framing none wan-encapsulation ppp
interface create ip to_hqsite address-netmask 120.210.23.34/28 port t1.3.2 up
!-----------------------------------------------------------------------------
!Configure RIP:
!-----------------------------------------------------------------------------
rip add interface to_msp_mppp
rip add interface to_msp_ft1
rip add interface to_hqsite
rip start