Filter
Top Products
11-10 Riverstone Networks RS Switch Router User Guide Release 8.0
Monitoring IP Parameters IP Routing Configuration Guide
The
ip show
commands display IP information, such as routing tables, TCP/UDP connections, and IP interface
configuration, on the RS. The following example displays all established connections and services of the RS.
The following example displays the contents of the routing table. It shows that some of the route entries are for locally
connected interfaces (“directly connected”), while some of the other routes are learned from RIP.
To display additional IP information, enter the following command in Enable mode:
rs# ip show connections
Active Internet connections (including servers)
Proto Recv-Q Send-Q Local Address Foreign Address
(state)
tcp 0 0 *:gated-gii *:* LISTEN
tcp 0 0 *:http *:* LISTEN
tcp 0 0 *:telnet *:* LISTEN
udp 0 0 127.0.0.1:1025 127.0.0.1:162
udp 0 0 *:snmp *:*
udp 0 0 *:snmp-trap *:*
udp 0 0 *:bootp-relay *:*
udp 0 0 *:route *:*
udp 0 0 *:* *:*
rs# ip show routes
Destination Gateway Owner Netif
----------- ------- ----- -----
10.1.0.0/16 50.1.1.2 RIP to-linux2
10.2.0.0/16 50.1.1.2 RIP to-linux2
10.3.0.0/16 50.1.1.2 RIP to-linux2
10.4.0.0/16 50.1.1.2 RIP to-linux2
14.3.2.1 61.1.4.32 Static int61
21.0.0.0/8 50.1.1.2 RIP to-linux2
30.1.0.0/16 directly connected - to-goya
50.1.0.0/16 directly connected -
to-linux2
61.1.0.0/16 directly connected - int61
62.1.0.0/16 50.1.1.2 RIP to-linux2
68.1.0.0/16 directly connected - int68
69.1.0.0/16 50.1.1.2 RIP to-linux2
127.0.0.0/8 127.0.0.1 Static lo
127.0.0.1 127.0.0.1 - lo
210.11.99.0/24 directly connected - int41
Show ARP table entries.
arp show all
Show IP interface configuration.
interface show ip
Show DNS parameters.
system show dns