Filter
Top Products
Riverstone Networks RS Switch Router User Guide Release 8.0 4-7
Hot Swapping Line Cards and Control Modules Hot Swapping A GBIC (RS 32000 and RS 38000 only)
2.
Tighten the captive screws on each side of the Switching Fabric Module to secure it to the chassis.
4.6 HOT SWAPPING A GBIC (RS 32000 AND
RS 38000 ONLY)
The Gigabit Ethernet line cards have slots for GBICs that can be installed at any time. You can hot swap the GBICs
installed in the line cards, as well as the line cards themselves. (For information on hot swapping line cards, see
Section 4.2, "Hot Swapping Line Cards.")
Warning
The GBIC and the host gigabit Ethernet line cards are sensitive to static
discharge. Use an antistatic wrist strap and observe all static precautions
when you remove or install a GBIC. Failure to do so could result in damage
to the GBIC and the host line card. Always leave the GBIC in the antistatic
bag or an equivalent antistatic container until it is ready to be installed.
4.6.1 Removing a GBIC from the Line Card
To remove a GBIC from its slot on the line card:
1.
Remove any cables connected to the GBIC.
2.
Locate the extractor tabs on either side of the GBIC.
3.
Using thumb and forefinger, compress the extractor tabs on both sides of the GBIC and pull it out of
the line card. See Figure 4-4.
4.
If storing or shipping the GBIC, insert the rubber dust protector into the GBIC to protect the fiber
ports.