Filter
Top Products
4-6 Riverstone Networks RS Switch Router User Guide Release 8.0
Hot Swapping a Switching Fabric Module (RS 8600 only) Hot Swapping Line Cards and Control Modules
Warning
You can only hot swap a Switching Fabric Module if two are installed on the
RS 8600. If only one Switching Fabric Module is installed, and you remove
it, the RS 8600 will crash.
The procedure for hot swapping a Switching Fabric Module is similar to the procedure for hot swapping a line card or
Control Module. You deactivate the Switching Fabric Module, remove it from the RS, and insert another Switching
Fabric Module in the slot.
Note
You cannot deactivate the Switching Fabric Module with the
system hotswap
command.
To deactivate the Switching Fabric Module:
1.
Press the Hot Swap button on the Switching Fabric Module you want to deactivate.
The Online LED goes out and the Offline LED lights. Figure 4-3 shows the location of the Offline LED and Hot
Swap button on a Switching Fabric Module.
Figure 4-3 Location of offline LED and hot swap button on a switching fabric
module
4.5.1 Removing the Switching Fabric Module
To remove the Switching Fabric Module:
1.
Loosen the captive screws on each side of the Switching Fabric Module.
2.
Pull the metal tabs on the Switching Fabric Module to free it from the connectors holding it in place
in the chassis.
3.
Carefully remove the Switching Fabric Module from its slot.
4.5.2 Installing a Switching Fabric Module
To install a Switching Fabric Module:
1.
Slide the Switching Fabric Module all the way into the slot, firmly but gently pressing to ensure that
the pins on the back of the module are completely seated in the backplane.
Note
Make sure the circuit card (and not the metal plate) is between the card guides.
Check both the upper and lower tracks.
G86-SWF
Switching Fabric
Active
Online
Swap
Hot
Offline