Filter
Top Products
Riverstone Networks RS Switch Router User Guide Release 8.0 17-115
MPLS Configuration Traffic Engineering
The following is the
mpls show label-switched-path LSP2 verbose
command on R1 that shows the selected
path for LSP2 in the
cspf-path
section (shown in bold in the example output below). Note that the hops are the
interfaces where the administrative group ’green’ is applied on the routers. This LSP also has a bandwidth of 8 Mbps
reserved on the path.
Path-Signalling-Parameters:
attributes: <>
inherited-attributes: <>
retry-limit: 5000 retry-int: 3 sec.
retry-count: 5000 next_retry_int: 0.000000 sec.
bps: 0 preference: 7
hop-limit: 255 opt-int: 600 sec.
ott-index: 3 ref-count: 1
mtu: 0
cspf-path: num-hops: 4
153.1.1.13 - strict
153.1.1.12 - strict
192.1.1.15 - strict
185.1.1.24 - strict
include: red
record-route:
153.1.1.12
192.1.1.15
185.1.1.24
R1#
mpls show label-switched-paths LSP2 verbose
Label-Switched-Path: "LSP2"
to: 124.124.124.124 from: 113.113.113.113
state: Up lsp-id: 0x12
proto: <rsvp> protection: none
setup-pri: 7 hold-pri: 0
attributes: <FROM_ADDR BPS>
Path-Signalling-Parameters:
attributes: <>
inherited-attributes: <>
retry-limit: 5000 retry-int: 3 sec.
retry-count: 5000 next_retry_int: 0.000000 sec.
bps: 8000000 preference: 7
hop-limit: 255 opt-int: 600 sec.
ott-index: 6 ref-count: 1
mtu: 0
cspf-path: num-hops: 5
153.1.1.13 - strict
153.1.1.12 - strict
186.1.1.26 - strict
187.1.1.15 - strict