Filter
Top Products
19
Setting Up the System for the First Time — Initial Setup Wizard
Chapter 1 Installation and Preparation
Setting Up the System for
the First Time — Initial
Setup Wizard
Design and specifications are subject to change without
notice.
When you turn on the Video Communication System for
the first time after installation, the setup wizard appears on
the display.
The items configured with the wizard can be changed later
using the setup menu.
Configuration items may differ depending on the software.
1
Select the language used for menus and messages from
the “Language” pull-down list.
Language: Available settings are English, Finnish,
French, German, Italian, Japanese, Korean,
Portuguese, Russian, Simplified Chinese, Spanish,
Swedish, Thai, and Traditional Chinese.
2
Click “Next”.
3
Make the following settings for the LAN.
The following examples assume that English has been
selected as display language.
DHCP Mode: Sets the DHCP (Dynamic Host
Configuration Protocol).
Auto: Automatically assigns your IP address,
subnet mask, gateway address and DNS
address.
Off: Deactivates DHCP. In this case you must set
your IP address, subnet mask, gateway
address and DNS address manually.
Host Name: Enter your host name.
IP Address: Enter your IP address.
Network Mask: Enter your subnet mask.
Gateway Address: Enter your default gateway
address.
DNS Address: Enter your DNS (Domain Name
System) server address.
When you set “DHCP Mode” to “Auto”, the assigned
IP address will be shown in the launcher menu (page
21) and Status & Info menu (page 51).
If you do not know the settings required for your LAN
configuration, contact your network administrator.
4
Click “End”.
The settings are saved.
To cancel the setting
Click “Cancel”.
The settings are not saved and the launcher menu appears.
To go back to the previous wizard
Click “Back”.
Note
1/2
Next
Language
Cancel
English
Note
2/2
End
DHCP Mode
IP Address
Network Mask
Gateway Address
DNS Address
Host Name
Auto Off
Back