Star Micronics XR-1000 Printer User Manual


 
Select 8-dot double-speed double-density
<EsC>
Y Cd>
<do,
Both
. . .
da>
1Bh 59h
27
89
-all>
<do> . . .
cdn>
cd>
<do> . . .
ain>
The command above selects 8-dot double-speed, double-density bit-image printing,
where cnO, and cd > are binary values (low byte fmt) representing the number of
data bytes following the command. The data bytes are represented by <do> . . . <dn>.
This command has the same effect as <ESC> * 2.
Set &dot quadruple-density
Both -
cEsc>
Z all>
<do> . . .
cdn>
1Bh 5Ah #o> all> cue . . . <dn>
27 90 cno>
cd>
<do> . . .
cdn>
The command above selects 8-dot quadruple-density bit-image printing, where
or& and cd> are binary values (low byte first) representing the number of data
bytes following the command. The data bytes are represented by <do> . . . <dn>.
This command has the same effect as cESC> * 3.
Redefine bit-image mode
Both
<Esc>
? Cd>
1Bh 3Fh al>
27 63
Cd>
The command above redefines a bit-image mode to another mode, where un& is
the mode to be redefined. This may take the ASCII values “K”, “L”, “Y” or “Z”.
on1 > is a binary value representing the mode to which cmo> is redefined, being a
value used after the cBSC> * command (0 through 7). If any of the modes
represented by cm& are subsequently selected, bit-image printing will now take
place in the mode as defmed by cm1 >.
Select 8-dot graphics
Standard
cEsc> A on> -ato> cd> <do> . . .
<de
1Bh
5Eh on> 010>
cd> <do> . . .
cdn>
27 94 cm> OIO, cd> <do> . . .
cdn>
The command above selects the 9dot bit image mode, where cm> is a binary value
representing the graphics mode (see table below), and cno> and cd> are binary
54