Star Micronics XR-1000 Printer User Manual


 
The command above controls the operation of the ASF, where <EM> is the ASCII
code 19h, and <n> may take the binary values OOh or 04h or the ASCII values “R”
or “T’. The effect of these values is summarized below:
1 Value 1 Effect
OOh Select manual mode
Mh Select auto mode
“R”
Eject paper
‘T
Set top print position. This parameter must be
followed by another binary value (>l) signify-
ing the distance (in l/6 inch units) at which
printing should start below the top of the paper.
These commands will be ignored if the ASF has not been selected.
ASCII command sequences
The command above sequences anz not preceded by a <ES0 or <FS> character, but
instead are preceded by double parentheses, thus “((“. They apply equally to both the
standard and the IBM emulation modes. They are given below:
I Select font
(
(
F
1 1
Cn>
28h 28h
46h
29h 29h Cn>
40
40
70
41 41
Cn>
The command above selects a font, where -UD is an ASCII value which may take
the following values:
OD Effect
‘. 0 *, courier
4‘ 1 9. SanSaif
cm Effect
6. 5 9,
OCR-B
,a 6 9,
TW-Light
6‘ 9.
2 Letter-Gothic “7”
Cinema
“3”
orator
‘Y
Draft
I “4” I Script
I I
63