FC-210/310
ERROR CODES AND SELF-DIAGNOSIS
1 - 6 February 2002 © TOSHIBA TEC
1. 2 Self-Diagnosis Mode
Mode Starting Contents Exit
Control panel check [0]+[1]+[POWER] All control panel LEDs are lit, [CLEAR] or
mode and all LCD pixels are turned [POWER]OFF/ON
ON/OFF repeatedly.
Test mode [0]+[3]+[POWER] Input/output signals are checked.
[POWER]OFF/ON
Test print mode [0]+[4]+[POWER] A test pattern print is made.
[POWER]OFF/ON
Adjustment mode [0]+[5]+[POWER] Adjustment of various items
[POWER]OFF/ON
Setting mode [0]+[8]+[POWER] Setting of various items
[POWER]OFF/ON
List printing mode [9]+[START]+[POWER] Printing of list of 05 and 08 code
[POWER]OFF/ON
data
Note: Starting for various modes:
While pressing simultaneously the two digital keys corresponding to the mode you want to set
(for example, [0] and [5]), turn ON the main switch [POWER].
0 1
CLEAR
CLEAR
POWER OFF/ON
(LEDs light/LCD flashes)
Power
(Check Keys)
(Exit)
(Exit)
or
START
START
<Operation procedure>
• Control panel check mode (01) :
Notes: 1. During the “Check keys” state, [CLEAR] alone can exit.
During the “LEDs light/LCD flashes” state, [CLEAR] can clear the mode.
2. Check keys :
Any key with LED (when it is pressed, the LED goes out.)
Any key without LED (when it is pressed, an indication is displayed in the message area.)
• Test mode (03) : Refer to "1.2.1 Input check (Test mode 03)" and "1.2.2 Output check
(Test mode 03)".
• Test print mode (04) : Refer to "1.2.3 Test print mode (04)".
• Adjustment mode (05) : Refer to "1.2.4 Adjustment mode (05)".
• Setting mode (08) : Refer to "1.2.5 Setting mode (08)".
