Filter
Top Products
FC-210/310 ADJUSTMENT 2 - 36 February 2002 © TOSHIBA TEC
Notes :
1. When winding the wires on the pulleys,
take the following precautions:
· Do not wind the wire on the pulley with
the wire twisted.
· Wind the wire strongly so that all the
turns of the wire are in firm contact with
the surface of the pulley.
· Each time you wind a turn on the pulley,
push it to the preceding turn so that all
the turns are closely wound.
2. When fitting wire holder jigs, take care so
that the turns wound on the pulleys do not
move or unwind.
No gap should exist.
e.g. Front side
<Relationship between wound turns and wire holder jigs>
3-mm ball
terminal
Pulley
Wire holder jigs
Front side Rear side
Wire holder jig