Filter
Top Products
February 2002 © TOSHIBA TEC 5 - 39 FC-210/310 UPDATING THE FIRMWARE
5.3.2 Engine firmware
The procedure to update the engine firmware (engine ROM/LGC board, scanner ROM/SCM board and
printer ROM/IMC board) is described in this section.
(1) Jig board
The engine ROM/LGC board uses K-PWA-DLS-320, the scanner ROM/SCM board and the printer
ROM/IMC board use K-PWA-DLM-320 as a jig board to update the engine firmware.
When updating the engine ROM/LGC board, use only the socket for ROM1 of K-PWA-DLS-320.
(The socket for ROM2 is not used.) ( Page. 5-32)
Note: Pay attention to the position and direction of the ROM when it is attached to the jig board.