Filter
Top Products
February 2002 © TOSHIBA TEC 2 - 33 FC-210/310 ADJUSTMENT
2.9 Adjustment of the Scanner Section
2.9.1 Carriages
(a) Installing carriage drive wires
When replacing the carriage drive wires with new wires, proceed as illustrated below:
Notes:1. Since the carriage drive wires are applied with proper tension by tension springs, there is no
need for tension adjustment.
2. Check that the wire tension is identical for both front and rear wires and is properly applied.
[Front side]
[Rear side]
Carriage-1
Carriage-2
Tension spring
Wire guide
Idle pulley
Hook
Wire pulley
Carriage-1
Hook
Wire guide
Idle pulley
Tension spring
Wire pulley
Carriage-2