Toshiba 310 Copier User Manual


 
February 2002 © TOSHIBA TEC 4 - 15 FC-210/310 TROUBLESHOOTING
Is the connector J5 on the punch driver PC board disconnected?
Is the harness connecting between the punch driver PC board and front door switch (MS2P) open-
circuited?
YES
Connect the connector securely. Replace the harness.
NO
Is the front door switch working properly?
NO
1. Connect the connector of the front door switch securely.
2. Replace the front door switch.
YES
Is the problem solved by replacing the punch driver PC board?
YES
End
NO
Replace the finisher controller PC board.
[EA5] Finisher stapling jam
Is there any paper remaining on the transport path in the finisher or copier, or on the stapling tray?
YES
Remove the paper.
NO
Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet
slided from the staple case?
YES
End
NO
Is the connector J8 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and staple home position sensor
(PI22) open-circuited?
YES
Connect the connector securely. Replace the harness.
NO
Is the staple home position sensor working properly?
NO
Replace the stapler unit.
YES
Replace the finisher controller PC board.