Filter
Top Products
February 2002 © TOSHIBA TEC 2 - 17 FC-210/310 ADJUSTMENT
Step 2
In case of Ꭿ:
Tighten the mirror-1 adjustment screw (CW).
ৎ Normal image
In case of ൳:
Loosen the mirror-1 adjustment screw (CCW).
ৎ Normal image
Note: After the image distortion adjustment, when the
adjustment screws of mirror-1 and -2 are turned,
lock the adjustment screws using the adhesive
“BOND-1324” for screw locking .
Mirror-1
[Application Method of the Adhesive for the Screw
Locking]
(1) Adjust the image distortion.
(2) Remove the original glass and the indicator unit.
(3) Move carriage-1 toward the paper exit side.
(4) Apply the adhesive (BOND-1324) to the adjust-
ment screws of carriage-1 and -2.
Mirror
Note:
Application Method
*Apply good quantity of the adhesive to the “Ap-
plication area”.
*The adhesive needs 12 hours to harden com-
pletely.
(5) Confirm that there is no dust or stain on mirror-
1, -2 or -3 or the shading correction plate.
(6) Install the indicator unit and the original glass.
Application area
Carriage frame