Filter
Top Products
7-4 User’s Manual
HW Setup
You can override the settings and manually select a boot device by
pressing one of the following keys while the computer is booting:
*1
The floppy disk drive is looked for when the boot disk is contained in
external floppy disk drive.
*2
In this computer, CD-ROM refers to the Fixed optical disc drive.
*3
Only the model with two HDDs is supported.
To change the boot drive, follow the steps below.
1. Hold down F12 and switch the computer on.
2. The following menu will be displayed with, from left to right, icons to
allow you to start from (a) the built-in hard disk drive 1, (b) the built-in
hard disk drive 2, (c) the optical drive, (d) a floppy disk drive, and (e) the
network.
CD-ROM −> LAN −>
HDD −> FDD
The computer looks for bootable files on devices
in the following order: 1. CD-ROM
*2
, 2. LAN, 3.
hard disk drive, 4. floppy disk drive
*1
.
U Selects the USB floppy disk drive.
N Selects the network.
1 Selects the primary hard disk drive.
2
Selects the primary hard disk drive 2
*3
.
C
Selects the CD-ROM
*2
.
FDD −> HDD −>
CD-ROM −> LAN
The computer looks for bootable files on devices
in the following order: 1. floppy disk drive
*1
, 2.
hard disk drive, 3. CD-ROM
*2
, 4. LAN.
HDD −> FDD −>
CD-ROM −> LAN
The computer looks for bootable files on devices
in the following order: 1. hard disk drive, 2. floppy
disk drive
*1
, 3. CD-ROM
*2
, 4. LAN.
Please note that a highlighted bar will only appear under the selected
device.