Filter
Top Products
4
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4 - 33
[F] Folding drive unit
(1) Take off the saddle unit.
P.4-26 "[A] Saddle unit"
(2) Release the harness out of 11 clamps, and
then disconnect each connector of CN11 and
CN14 on the SDL board.
Fig. 4-91
(3) Disconnect the connector of the folding blade
home position sensor. Break binding wire at
4 positions and release the harness from 10
clamps of the folding drive unit.
Fig. 4-92
(4) Remove one clip and then remove the bush-
ing.
Fig. 4-93
SDL board
Clamp
Clamp
Binding wire
Connector
Clip
Bushing