Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION
4 - 8
[L] Left upper cover
(3) Release the harness from 1 clamp.
Note:
When installing the right cover, pull the har-
ness from the board access cover side tightly
and fix it with a clamp in order not to permit
the harness to slack off.
Fig. 4-21
(4) Remove 4 screws, and then take off the right
cover by sliding it upward.
(5) Disconnect the relay connector from the con-
nection sensor. Then take off the right cover.
Note:
When installing the right cover, hang the 2
hooks of the cover on the holes of the frame.
Fig. 4-22
(1) Remove 3 screws, and then take off the left
upper cover.
Fig. 4-23
Clamp
Right cover
Hook
Hook
Left upper cover