Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENTS
5 - 6
5.3 Stapling/folding position adjustment in saddle unit
Perform this adjustment when the saddle control PC board was replaced or the stapling/folding position
must be changed for some reason.
Prepare 2 types of booklet samples using the main unit and use them for adjustment accordingly.
(1) Create 2 types of booklet samples (1 set each) using the main unit.
(2) Measure the stapling and folding positions of the samples, and then perform adjustment accord-
ingly.
For stapling and folding, paper on the stacker of the stacker unit is moved to an exclusive mech-
anism for stapling or folding. Therefore adjustment must be performed individually for the folding
stopping position of the stacker and the stapling stopping position.
* Check the folding position at the centerfold page of the sample.
Fig. 5-6
* Check the stapling position at the centerfold page of the sample.
Fig. 5-7
Sample 1 Sample 2
Media type Recomended paper Recomended paper
Paper size A4 A3
Number of sheets 5 sheets 5 sheets
Paper exit
direction
Center
fold
page
-2mm - +2mm
-2mm - +2mm
Do not include the
width of the staples
Staple
When the staples are bent
-0.5mm - +0.5mm
-0.5mm - +0.5mm
Folding lineFolding line
Staple