Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION
4 - 16
(8) Release the harness out of 5 clamps, and
then disconnect each connector of CN3,
CN4, CN5, CN6, CN8, CN10 and CN12 on
the FIN board.
(9) Disconnect the relay connector.
Fig. 4-44
(10) Remove 4 screws, and then take off the
buffer unit.
Fig. 4-45
Note:
When the buffer unit has been taken off,
place the unit as shown in the figure in order
not to damage the buffer guide or the paper
pusher plate.
Fig. 4-46
FIN board
Relay
connector
Clamp
Buffer unit
Paper pusher plate
Buffer guide