Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
TROUBLESHOOTING
6 - 10
[CDE0] Paddle motor (M3) abnormality
* The [CDE0] error also occurs when the error [ED15] has occurred consecutively for 3
times or when it occurred during NIC initialization.
Is there any mechanical problem with the paddle is rotated?
YES Fix the mechanism.
NO
Is the harness between the paddle motor (M3) and the CN22 of the finisher control PC board
(FIN) disconnected or open circuited?
l
YES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
1. Replace the paddle motor (M3).
2. Replace the finisher control PC board (FIN).
[EA70] Stack exit belt home position error
Is there a disconnection of the connector, incorrect installation or breakage of the stack exit belt
home position sensor (S9)?
l
l
YES • Reconnect the connector securely if there is any disconnection.
• Reinstall the sensor correctly if there is any incorrect installation.
• Replace the sensor if there is any breakage.
NO
Is the harness between the stack exit belt home position sensor (S9) and the CN18 of the fin-
isher control PC board (FIN) disconnected or open circuited?
Is the harness between the stack transport motor (M8) and the CN17 of the finisher control PC
board (FIN) disconnected or open circuited?
l
YES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
Replace the finisher control PC board (FIN).
[CC30] Stack transport motor (M8) abnormality
* The [CC30] error also occurs when the error [EA70] has occurred consecutively for 3
times.
Is there any mechanical problem when the stack transport belt is moved?
YES Fix the mechanism.
NO
Is the harness between the stack transport motor (M8) and the CN17 of the finisher control PC
board (FIN) disconnected or open circuited?
l
YES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
1. Replace the stack transport motor (M8).
2. Replace the finisher control PC board (FIN).