Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION
4 - 26
4.3 Units (Saddle section: MJ-1104)
[A] Saddle unit
(1) Take off the front lower cover.
P.4-4 "[E] Front cover / Front upper cover
/ Front lower cover"
(2) Remove 3 screws, and then take off the SDL
board cover.
Fig. 4-71
(3) Release the harness out of 3 clamps, and
then disconnect each connector of CN10 and
CN13 on the SDL board.
Fig. 4-72
(4) Place a table beneath the pulled-out saddle
unit to steady it.
Note:
Store (flip up) the saddle unit support before
placing a table beneath the unit.
(5) Remove 8 screws and store the right and left
rails.
Fig. 4-73
SDL board cover
SDL board
Clamp
Table beneath
Saddle unit
support