Filter
Top Products
Installing the Slim select bay module
To install the slim select bay module, follow the steps below and refer to Figure 4-8 and 4-9.
1. Install the connector cover holder to the optical drive assembly and secure it with
the following screws.
• M2×6S BIND screw ×1
• M2×22S BIND screw ×1
2. Install the connector cover to the optical drive assembly and secure it with the
following screw.
• M2×3S S-FLAT HEAD screw ×1
3. Install the connector cover and connector to the optical drive assembly and secure it
with the following screws.
• M2×6S BIND screw ×2
4. Insert the slim select bay module into the computer to connect it to the connector on
the system board. Press to ensure a firm connection.
5. Remove the following screw from the screw hole. Then secure the latch with the
removed screw. (The slim select bay is locked.)
• M2.5×4B FLAT HEAD screw ×1
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-21