Filter
Top Products
8. Disconnect the keyboard cable from the connector CN3200 on the system board and
remove the keyboard.
Keyboard cable
CN3200
Keyboard
Figure 4-13 Removing the keyboard
Installing the Keyboard
To install the keyboard, follow the steps below and refer to Figure 4-10 to 4-13.
1. Place the keyboard face down on the palm rest.
2. Connect the keyboard cable to the connector CN3200 on the system board.
3. Extra portion of the keyboard cable must be put under the keyboard support.
4. Slide the keyboard support plate to the below and set it while sticking the adhered
portion on the CPU holder.
5. Secure the keyboard support plate with the following screw.
• M2.5×4B FLAT HEAD screw ×1
6. Turn the keyboard face up and set it while engaging three latches. Make sure that
there is no gap between the keyboard and edge of the palm rest.
7. Secure the keyboard with the following screws.
• M2.5×4B FLAT HEAD screw ×2
8. Install the speaker cover.
4-24 [CONFIDENTIAL] TECRA S3 Maintenance Manual (960-532)