Filter
Top Products
4.12 Switch membrane
Removing the Switch membrane
To remove the switch membrane, follow the steps below and refer to Figure 4-17.
1. Remove the following screw and lift up the upper part of the right side of the switch
cover to remove.
• M2.5×4B FLAT HEAD x1
2. Peel off the insulator and disconnect the switch cable from the connector CN3260
on the system board.
3. Remove the following screw and slide the switch membrane to the right to remove.
• M2.5×4B FLAT HEAD x1
Switch cover
Switch membrane
CN3260
Switch cable
M2.5×4B FLAT HEAD
M2.5×4B FLAT HEAD
Insulato
r
Figure 4-17 Removing the SW membrane
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-29