Filter
Top Products
3. Peel off the glass tape and disconnect the touch pad cable from the connector on the
touch pad.
4. Remove the following screws and touch pad.
• M2.5×4B FLAT HEAD screw ×2
M2.5×4B FLAT HEAD
Touch pad
Glass tape
M2.5×4B FLAT HEAD
Touch pad cable
Figure 4-15 Removing the touch pad
Installing the Touch pad
To install the touch pad, follow the steps below and refer to Figure 4-14 and 4-15.
1. Install the touch pad and secure it with the following screws.
• M2.5×4B FLAT HEAD screw ×2
2. Connect the touch pad cable to the connector on the touch pad and stick the glass
tape.
3. Install the touch pad assembly to the slot of the palm rest while engaging the latches.
4. Connect the touch pad cable to the connector CN3201 on the system board.
4-26 [CONFIDENTIAL] TECRA S3 Maintenance Manual (960-532)