Filter
Top Products
Assembly of Cover Ass’y Bottom (L), Sheets, Light guide, Tape Adhesive and Board Ass’y.
1. Assembly of Cover Ass’y Bottom and Screw (2 Point).
CAUTION: Maximum value of torque with Screw should be below 2.0kgf.cm.
2. Assembly of Light Guide and Sheets. (Reflector Sheet fixing with one Double Tape,
Diffuser Sheet fixing with one Double Tape.)
CAUTION: No penetration of foreign body is indispensable with no scratch on the
surface of each Sheet and Light guide.
3. Assembly of Tape adhesive used for Sheets fixing (4 Points).
4. Assembly of Board Ass’y.
CAUTION: Pressure or stress should not be given on PCB and TCP.
Figure 4-61 Replacing LG.Philips fluorescent lamp (XGA) (5)
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-81