Filter
Top Products
Installing the Hinge
To install the hinge, follow the steps below and refer to Figure 4-51 to 4-53.
1. Install the left hinge and secure it with the following screw.
• M2.5×6S Tapping screw ×1
2. Install the right hinge and secure it with the following screws.
• M2.5×6S Tapping screw ×2
3. Install the SPG GND VGA fin and secure it with the following screw.
• M2×3S S-FLAT HEAD screw ×1
4. Set the middle frame in place on the display cover and secure them with the
following screws.
• M2×4B BIND screw ×4
• M2.5×6S Tapping screw ×2
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-71