Filter
Top Products
_____________________________________________________________________
B096-016 B096-048 and B092-016 User Manual Page 163
Alert Configuration
You can add an email alert to the system from the command line by following these
instructions:
Determine the total number of existing alerts (if you have no existing alerts) you can assume
this is 0.
# /bin/config –-get=config.alerts.total
This command should display output similar to:
config.alerts.total 1
Note that if you see:
config.alerts.total
This means you have 0 alerts configured.
Your new alert will be the existing total plus 1. So if the previous command gave you 0, then
you start with user number 1. If you already have 1 alert, your new alert will be number 2, etc.
To configure an email alert to be sent to alert1@domain.org when the regular expression
“Cpu.*0.0% id,” matches logging on serial port 5, you would need to issue the following
commands (Assuming you have 1 previous alert in place):
# /bin/config –-set=config.alerts.alert2.email=alert1@domain.com
# /bin/config –-set=”config.alerts.alert2.pattern=.*0.0% id,”
# /bin/config –-set=config.alerts.alert2.port5=on
# /bin/config –-del=config.alerts.total=2
The following command will synchronize the live system with the new configuration.
# /bin/config –-run=alerts
14.7 SDT Host Configuration
SDT host TCP Ports
To setup the list of TCP ports for a host, you use the config command:
# config -s config.sdt.hosts.host3.tcpports.tcport1 = 23
# config -s config.sdt.hosts.host3.tcpports.tcport2 = 5900