Filter
Top Products
98
Activate Nagios notification if it is to be used for this event. In an SDT Nagios centrally managed
environment, you can check the Nagios alert option. On the trigger condition (for matched
patterns, logins, power events and signal changes), an NSCA check "warning" result will be sent
to the central Nagios server. This condition is displayed on the Nagios status screen and triggers
a notification. This can cause the Nagios central server itself to send out an email or an SMS,
page, etc.
Select from the list of all configured serial ports, hosts, power units, monitors and probes which
devices this new alert is to be applied to. Select Applicable Port(s) (serial) and/or Applicable
Host(s) and/or Applicable UPS(es) and/or Applicable RPC(s) and/or Applicable EMD(s) and/or
Applicable Alarm Sensor(s) that are to be monitored for this alert trigger
7.2.2 Select general alert type
Select the Alert Type (Connection, Signal, Pattern Match, UPS Status or Environment and Power) that is
to be monitored. You can configure a selection of different Alert types and any number of specific
triggers
Connection Alert - This alert will be triggered when a user connects or disconnects from the
applicable Host or Serial Port, or when a Slave connects or disconnects from the applicable UPS
Serial Port Signal Alert - This alert will be triggered when the specified signal changes state and
is applicable to serial ports only. You must specify the particular Signal Type (DSR, DCD or CTS)
trigger condition that will send a new alert