20
You will be prompted to log in. Enter the default
administration username and administration
password:
Username: root
Password: default
The above screen, which lists four initial installation configuration steps, will be displayed:
1. Change the default administration password on the System/Administration page (Chapter 3)
2. Configure the local network settings on the System/IP page (Chapter 3)
3. Configure port settings and enable the Serial & Network/Serial Port page (Chapter 4)
4. Configure users with access to serial ports on the Serial & Network/Users page (Chapter 3)
After completing each of the above steps, you can return to the configuration list by clicking in the top
left corner of the screen on the logo:
Note If you are not able to connect to the Management Console at 192.168.0.1 or if the default
Username / Password were not accepted then reset your Console Server (refer to Chapter 10)