Filter
Top Products
6 UNIX TCP/IP
102 Xerox WorkCentre 7232/7242 System Administration Guide
NOTE: The system default is used if no parameter is specified.
Specifying stapling
The following parameters can be specified for stapling.
NOTE: If several parameters are specified in the first lpr command, data may not print.
NOTE: For some print languages, the stapling parameter may be invalid.
Printing
To specify the output format of printing, enter the following command:
-C,[parameter],[parameter]
Enter a “,” (comma) after -C followed by the parameters which specify the output
format. To specify multiple parameters, separate them with “,”.
For example, to print a file named “file1”, two-sided on A4 (210 × 297 mm/8.3 × 11.7
inches) on printer fxPS, enter the following command:
%lpr -PfxPS -C,DUP,A4 file1
NOTE: If the parameter string of the -C option exceeds 64 characters, the operation
may not function correctly.
Parameter Description
STAPLETL Places one staple in the upper left corner of the prints.
STAPLETD Places two staples at the top of the prints.
STAPLETR Places one staple in the upper right corner of the prints.
STAPLELD Places two staples on the left side of the prints.
STAPLERD Places two staples on the right side of the prints.
STAPLEBL Places one staple in the lower left corner of the prints.
STAPLEBD Places two staples at the bottom of the prints.
STAPLEBR Places one staple in the lower right corner of the prints.