Filter
Top Products
NetWare Installation
Xerox WorkCentre 7232/7242 System Administration Guide 81
9. Select [IPv4 – Gateway Address], and then [Change Settings].
NOTE: If you do not wish to set the gateway address, leave this field blank.
10. Using the same method as in step 6, enter the Gateway Address.
11. Select [IPv4 – IP Filter], and then [Change Settings].
12. Select [Enabled] to filter access to the machine.
NOTE: If you do not wish to use the IP filter feature, select [Disabled].
NOTE: Use CentreWare Internet Services to register the IP addresses which are not
allowed to access the machine.
13. When you have finished establishing TCP/IP, select [Close] on the [Protocol
Settings] screen.
NetWare Setup
Use PCONSOLE or NetWare Administrator (NWADMIN) to create a print queue, print
server and printer, and assign the respective objects. For information on how to use
PCONSOLE or NWADMIN, refer to manual which comes with NetWare.
There are two ways to type the name: typeable (OU, O, etc.) and typeless. The user
must use the typeable name in order for it to work.
Example: ou=xxxx.o=yyyy.c=zzzzz
When using in the PSERVER mode, set as follows.
• Printer server name – Use the same device name as the target printer.
• Printer location – Set as Auto Load.
• Printer Type – Set as Parallel.
• Parallel Setting – Set as Auto Load.
For NetWare 5, only NWADMIN is available for use.
Workstation Setup
Install the PCL print driver on the NetWare client computer. Refer to the HTML
document on PCL Print Driver CD-ROM.
Test Print
To make sure that the machine has been installed on the network correctly, submit a
test print from each client workstation. Perform the following steps.
1. Open a document on a client workstation.
2. Select the machine as the printer.
3. Print the document on the machine and verify that it prints correctly.