Filter
Top Products
4 CentreWare Internet Services
60 Xerox WorkCentre 7232/7242 System Administration Guide
- Community Name (Read/Write): Enter the community name used for display
and update.
Default Trap Community Name:
- TRAP Community Name: Enter the trap notification community name.
System Administrator’s Login ID:
- System Administrator’s Login ID: Enter the name of the Key Operator.
• Enable SNMP v3 Protocol – Allows you to enable or disable the SNMP v3
protocol.
• Edit SNMP v3 Properties – Displays a page which allows you to set the following
SNMP v3 properties. This button is active only when the Secure HTTP (SSL)
feature is enabled.
Administrator Account:
- Account Enabled: Select to enable the Key Operator’s account.
- User Name: Displays the user name of the Key Operator.
- Authentication Password (minimum 8 characters): Enter the authentication
password using 8 to 32 characters.
- Confirm Authentication Password – Re-enter the authentication password for
verification.
- Privacy Password (minimum 8 characters): Enter the privacy password using
8 to 32 characters.
- Confirm Privacy Password: Re-enter the privacy password for verification.
Print Drivers/Remote Clients Account:
- Account Enabled: Select the check box to enable the print drivers/remote
clients account. This account allows client computers and drivers a limited
access to the features on the machine. If the machine does not have SNMP
v1/v2c enabled, and does not have this account enabled, SNMP clients will
not be able to communicate with the machine. The default passwords should
be used, unless the passwords have been changed on client computers.
- Reset to default Password – Click this button to reset your password to the
default.
• Advanced – Displays a page that contains the [Add UDP IPv4], [Add UDP IPv6
Address], [Add IPX Address], and [Delete] buttons.
- Add UDP IPv4 Address: This button displays the [SNMP Configuration -
IPv4] page, which allows you to set the following settings.
IP Trap Destination Address:
• IP Address: Enter the IPv4 address of the SNMP agent that you are setting
up to receive traps.
• UDP Port Number: Enter the UDP port number of the SNMP agent.
• SNMP Version: Select the SNMP version of the SNMP agent.