Filter
Top Products
Status and Service
Messages
Printer Jams and Troubleshooting 6-17
IDLE
The printer is on line, but no jobs
are in process.
No action needed.
INNER JAM
Media has jammed leaving the
OPC belt cartridge area.
Locate and remove the
jam.
MEDIA MISMATCH
The media detected in the
cassette doesn’t match the
media size setting.
Change the media in the
cassette or change the
media size setting.
MISFEED JAM
Media has jammed between the
cassette and the print engine.
Locate and remove the
jam.
NO PRNTREQ ERROR
A printer hardware error has
occurred.
Reboot the printer. If this
message continues to
appear, contact your
service provider. (Refer
to www.minolta-qms.com
for a complete list.)
OPTIONAL BIN REAR DOOR
OPEN
The lower feed unit (optional)
rear door is open.
Close door.
OUTER JAM
Media has jammed between the
print engine and the output tray.
Locate and remove the
jam.
OUTPUT BIN FULL
The media has exceeded the
limit (such as over 250 sheets of
20 lb [75 g/m²] bond) in the
output bin.
Remove the media from
the output bin.
OUTPUT BIN JAM
A media jam has been detected
between the fuser and output
tray rollers located near the top
cover.
Locate and remove the
jam.
PROCESSING...
The printer is currently
processing a print job.
No action needed.
PUT
SIZE
PAPER IN ANY BIN
Engine/Chain Inputbins is set to
On and a chained cassette is
empty.
Refill the cassette with
the specified size media.
This status message... means... Do this...