Filter
Top Products
Duplex Unit Problems
magicolor 6100 DeskLaser User's Guide6-26
3 If these solutions do not work, contact your local vendor.
Not All Pages Print
If the printer stops printing in the middle of your file, try the following:
1 Check your cable.
Be sure that you’re using a Centronics IEEE 1284 bidirectional parallel cable.
2 Make sure no one pressed the Cancel key while your job was printing.
3 Check the message window to see if the cassette you are using is out of
media.
Printing is Slow
If the printer is connected via the parallel port and is slow to begin printing large or
complex print jobs sent from Windows 95/98 operating system:
1 Check your cable.
Be sure that you’re using a Centronics IEEE 1284 bidirectional parallel cable.
2 Verify that the parallel port on your computer is configured for ECP mode
communication.
For information about ECP mode, see “Optimizing Printing Performance over a
Parallel Port,” in chapter 4, “Advanced Printer Operations.”
Duplex Unit Problems
General
Plain paper and limited thick stock up to 28 lb bond (105 g/m²) can be auto duplexed if
the optional duplex unit is installed. For heavier weights, manual duplexing is recom-
mended.
In general, if you’re having output problems with your duplex unit, try the following:
1 Ensure that you are using correct media.
Do not duplex envelopes, glossy stock, labels, transfer media, or transparencies.